Re: SA750 Gettimg started...Rib Making


[ Follow Ups ] [ Post Followup ] [ Starduster Bulletin Board ] [ FAQ ]

Posted by Cam Meek (24.9.14.219) on October 07, 2005 at 12:34:56:

In Reply to: SA750 Gettimg started...Rib Making posted by Eric D on October 06, 2005 at 23:03:30:

Yes, the capstrips are slotted. There are probably many ways to do it. What I did was get a Dremel router table and a .065 router bit for the Dremel that mounts under the table. Set the height of the bit above the table to get the desired depth of cut into the capstrip. And set the fences on the table to get the slot centered. I can't remember if the .065 bit provided the correct width of the slot. So you may need a different sized bit. Or, if the bit provides a slot that is too thin, you can always route the capstrip twice. Once with each side of the capstrip against the table fences to provide a wider slot.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Starduster Bulletin Board ] [ FAQ ]