Streamlineflying wire ends


[ Follow Ups ] [ Post Followup ] [ Starduster Bulletin Board ] [ FAQ ]

Posted by Randy (206.253.32.109) on October 04, 2005 at 20:31:52:

When I purchased my acro project the prior owner had lost several of the ends for the flying wires. Are these ends the AN665 clevis tie rod ends or are they something special? I have saw a lot of comments about rolled vs cut threads on the board. Also wondering about the "1/4x5/16 male fork ends" the plans call for on the tail struts and roll struts. Can sombody give me the spruce part number. Does spruce carry these iteams under the old starduster SA750 dash numbers that where on the pre spruce plans or is there an AN number I should look for?


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Starduster Bulletin Board ] [ FAQ ]